EPLANT-Piping V2024.0

Documentation of changes with respect V2023.0

Listed below are the most important changes of this version with respect to the former 2023.0 one. Current version is compatible with AutoCADŽ from version 2004 up to 2024.
Current version is also compatible with ZWCAD from version 2020 up to 2025.

GRAPHIC MODULE

It contains the following changes with respect to the 2023.0 version:

• ZWCAD 2025. This EPLANT-Piping version is compatible with current ZWCAD 2025.
• New Components. 12 new 3D Instruments components where created with the following COD codes: IP3, IP4, IP5, IP6, IP7, IP8, IT3, IT4, IT5, IT6, IT7, IT8.
• Isometric MTO. The new Elbow Cut Angle field is available for listing and it is also available to discriminate between Elbows based on their Cut Angle, if any. See the tutorial for details.
• Error Corrections
  - Error in projecting Pipe Components in 2D plans generation was fixed: it used to manifest itself in some cases due to unknown causes.

DATA BASE MODULE

It contains the following changes with respect to the 2023.0 version:

• Piping Material The new ANG_S field is available in the Piping Original Data Table: it contains the Elbow Cut Angle, if any, and it is available to be included in Piping Material Reports.

October 03th, 2024.